Engine Parts

Boat, impellers, Sierra, thermostats, Gear sets, Water Pumps,
!
Larger picture

Seloc Engine Manual

Seloc Manuals are marine industry preferred. They take the technician step by step from start to finish with detailed photos of actual repairs and the components being serviced. We currently have 29 manuals available for the most popular engine repair needs. Three of these cover PWC. These manuals are known for their extensive photographs and illustrations.
Larger picture

Impellers & Water Pump Kits

Original Sierra Water Pump Impellers and Kits

Replace impellers yearly for safety

 

Larger picture

OutDrive Gasket Set

OUTDRIVE GASKET SETS

Our gasket sets are packaged complete with the needed gaskets, o-rings and grommets. In many cases, our complete gasket sets are priced less than just the OE outdrive gasket.

Larger picture

Bellows

BELLOWS

Located and mounted between the gimbal housing and outdrive unit, these items seal out moisture from entering three critical areas; drive shaft, shift cable and exhaust. They are manufactured domestically of high grade rubber and are packaged with stainless steel clamps. Our 18-2601 transom seal kit is ideal when servicing the drive unit. It comes complete with an outdrive gasket kit, gimbal bearing, shift arm and all necessary bellows and stainless steel clamps.

Larger picture

Fuel Water Seperator

Fuel Filter Water Seperator

18-7852 : Universal filter and bracket kit (uses 1/4"npt line fittings)

Fuel Water Seperator

Replaces most major Mfg. original equipment

18-7845 : replaces Merc 35-60494A4, Suzuki 99105-20001, Yamaha ABA-SEPAR-AT-OR

18-7844 : replaces Merc 35-807172 (same as 18-7845 except shorter for tight places)

18-7846 : OMC fuel water seperator

Larger picture

Tune Up Kit

Larger picture

Spark Plug Wires

Larger picture

Thermostat

Larger picture

Mercury Power Tilt Trim Hoses

POWER TILT/TRIM HOSES

Located between the hydraulic cylinders on the drive unit and the hydraulic pump within the boat, these hoses carry hydraulic fluid to the cylinders in order to raise and lower the drive unit. Some older model boats come equipped with power tilt. Using a switch mounted on the dash, the drive unit could be raised to load and unload the boat from the trailer. In a power tilt application, the drive unit must be completely down in order to operate properly.

Larger picture

U-Joint_Gimbal Bearing

Larger picture

Shift Cables

Larger picture

Engine Coupler

Larger picture

Champion Spark Plugs

 

Larger picture

Champion Stainless Steel Spark Plugs

 

Lower Gear Case Plugs & Gaskets

Change your O-rings and gaskets when you change oil.  Stainless plugs.